Filter
Top Products
20
STOPPING
1) Release the throttle lever (6) fully, and when the engine
rpm has lowered, set the I-O switch (1) to STOP the
engine will now stop.
2) Be aware that the cutting head may not stop immediately
and allow it to slow down fully.
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
When it is necessary to adjust the low-speed rotation (idling), perform it by the carburetor adjusting screw.
CHECKUP OF LOW-SPEED ROTATION
– Set the low-speed rotation to 3000min
-1
.
If it is necessary to change the rotation speed, regulate
the adjusting screw (illustrated on the left), with Phillips
screwdriver.
– Turn the adjusting screw to the right, and the engine
rotation will increase. Turn the adjusting screw to the left,
and the engine rotation will drop.
– The carburetor is generally adjusted before shipment. If it
is necessary to readjust it, please contact Authorized
Service Agent.
CAUTION: The cutting tools mentioned below must only
be resharpened by an authorized facility.
Manual resharpening will result in imbalances
of the cutting tool causing vibrations and
damage to the equipment.
– cutter blade (star blade (4 teeth), eddy blade (8 teeth))
An expert resharpening and balancing service is provided
by Authorized Service Agents.
NOTE: To increase the service life of the cutter blade (star
blade, eddy blade) it may be turned over once, until
both cutting edges have become blunt.
RESHARPENING THE CUTTING TOOL
STOP
I-O switch (1)
Throttle lever (6)
Adjusting screw
Carburetor