Filter
Top Products
Sharpening the saw chain
MAINTENANCE
CAUTION:
Before doing any work
on
the guide bar
or
chain, always switch
off
the engine and pull the plug cap
off
the spark plug (see "Replacing the spark plug"). Always
wear
protective gloves!
The chain needs sharpening when:
The sawdust produced when sawing damp wood looks like
wood flour.
The chain penetrates the wood only under great pressure.
The cutting edge is visibly damaged.
The saw is pulled to the left or right when sawing. This is caused
by uneven sharpening of the chain.
Important: Sharpen frequently, but without removing too
much metal!
Generally,
2
or
3
strokes of the file will be enough.
-----l
Have the chain resharpened at a service centre when you have
already sharpened it yourself several times.
Proper sharpening;
CAUTION: Use only chains and guide bars designed for
this saw (see the Extract from the spare-parts list)l
All
cutters must be of the same length (dimension a). Cutters
with different lengths result in rough running of the chain and
can cause cracks in the chain.
The minimum cutter length:
0.1 l"(3
mm). Do not resharpen the
chain when the minimum cutter length has been reached; at
this point, the chain must be replaced (see theLExtract from the
spare-parts
list
and "Replacing the saw chain").
The depth of the cut is determined by the difference in height
between the depth limiter (round nose) and the cutting edge.
The best results are obtained with a depth-limiter depth of
.025"
.025"
(0.65
mm) (0.65 mm)
min.
a
:
'4
3
mm
(0.11")
-
-
I
I
,025"
(0.65
mm).
The sharpening angle of
25"
must be identical for all cutters!
Different angles result in a roughly, irregularly running chain,
increase wear and tear and cause chain beakage.
The front rake
60"
of the cutter results from the cut depth of the
round file.
If
the proper file is used
in
the right manner, the
correct front rake will be obtained automatically.
26