Filter
Top Products
Important note
on
bio-degradable chain
oils
If you are not planning
to
use the saw again for an
extended period of time. empty the
Oil
tank and Put in a
Small amount
of
regular engine oil
(SAE
30)3
and then
run the saw for a time. This is necessary to flush out all
remaining bio-degradable oil from the oil tank, oil-feed
leave sticky residues over time, which can cause dam-
age to the oil pump or other parts.
The next time you use the saw, fill the tank with BIOTOP
chain oil again. In case of damage caused by using waste oil
or unappropriate chain oil the product guarantee will be null
and void,
and
guide
as
many
such
Oils
tend
to
Your salesman will inform
you
about the
use
of
chain
oil.
NEVER USE WASTE OIL
Waste oil is very dangerous for the environment.
Waste oil contains high amounts of carcinogenic substances.
Residues in waste oil result in a high degree of wear and tear
at the oil pump and the sawing device.
In case of damage caused by using waste
oil
or unappropriate
chain oil the product guarantee will be null and void.
Your salesman will inform you about the use of chain oil.
AVOID SKIN AND EYE CONTACT
Mineral oil products degrease your skin. If your skin comes in
contact with these substances repeatedly and for an extended
period of time, it will desiccate. Various skin deseases may
result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
I
u
waste
oil
t-1
&
-
A
&
chain
oil
B
fuelloil
mixture
Refuelling
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be switched
off!
Thoroughly clean the area around the caps,
to
prevent dirt from
getting into the fuel or oil tank.
Unscrew the cap and
fill
the tank with fuel (fuel/oil mixture) or
chain oil
as
the case may be. Fill up to the bottom edge
of the tiller neck. Be careful not to spill fuel or chain oil!
Tightly screw on the cap.
Clean screw cap and tank after refuelling.
Lubricating the chain
During operation there
must
always be sufficient chain oil in the
chain-oil tank to provide good chain lubrication. One filling is
sufficient for about one half-hour of continuous operation.
22