Filter
Top Products
P 2/ 5
Repair
[1] NECESSARY REPAIRING TOOLS
[2] DISASSEMBLY/ASSEMBLY
[2]-1. Fan, Armature
Description
Use for
Remove two Holder cap covers by
levering up with Slotted screwdriver.
Remove 13pcs. of 4x18 Tapping screws.
And separate Housing set (R) from Housing
set (L).
Separate Motor section (Endbell complete, Armature,
Yoke unit, Fan 95) from Housing set (L).
Note: Do not lose Hanger
Remove two Brush holder caps and Carbon brushes.
Socket bit 8-55 (width across flats: 8mm) Disassembling/ Assembling M5-8 Hex nut for Fan 95
DISASSEMBLING
Holder cap cover
(2pcs.)
Carbon brush
(1) Remove Carbon Brush as illustrated in Fig. 1.
(2) Separate Housing set (R) and take out Motor section as illustrated in Fig. 2.
Brush holder cap (2pcs.)
Housing set (R)
Housing set (L)
Housing set (R)
Motor section
Fig. 1
Fig. 2
Hanger
CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.
1. Separate Motor section
from Endbell complete.
Fig. 3
(3) Fan 95 and Armature can be replaced as illustrated in Fig. 3.
2. Hold Fan 95 by hand and turn M5-8 Hex nut for Fan 95
clockwise using cordless impactdriver with Socket bit 8-55.
Note: M5-8 Hex nut has a left handed thread.
Fan 95
Fan 95
Socket bit 8-55 Cordless impactdriver
M5-8 Hex nut
Flat washer 5
Flat washer 8
Fan 95
Yoke unit
Armature
Endbell
complete