Filter
Top Products
27
(3) Ignition System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Miscellaneous Items Used in Above Systems
(i) Hoses, Sealing gaskets, belts, connectors, and assemblies.
Makita USA, Inc will furnish with each new engine written instructions for the maintenance and use of the engine by
the owner.
(e) MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times
recommended in the 2007 and later Owner’s Manual and to retain proof that inspection and maintenance services
are performed at the times when recommended. Makita USA, Inc will not deny a warranty claim solely because you
have no record of maintenance;
however, Makita USA, Inc may deny a warranty claim if your failure to perform required maintenance resulted in the
failure of warranted part. The proof, which you maintain, should be given to each subsequent owner of the engine.
You are responsible for performing the scheduled maintenance described below based on the procedures specified
in the 2007 and later Owner’s Manual. The scheduled maintenance below is based on the normal engine-operating
schedule.
PROCEDURE INTERVAL
1) Clean engine and check bolts and nuts.
Retighten if necessary.
:Every 8 hours(daily)
2) Check and refill engine oil (4stroke engine
only)
:Every 8 hours(refill daily up to upper limit)
3) Change engine oil (4stroke engine only) :Initial 20 hours and every 50 hours afterward
4) Check clogging of cooling air passage and
cylinder fins. Remove and clean if necessary.
:Every 8 hours (daily)
5) Clean air cleaner. :Every 8 hours (daily)
6) Check spark plug. Clean and adjust if
necessary.
:Every 8 hours (daily)
7) Check muffler exhaust outlet(or port).
Clean if necessary.
:Every 50 hours (monthly)
8) Check fuel filter. If clogged, replace with new
one.
:Every 50 hours (monthly)
9) Adjust valve clearance, if applicable (4stroke
engine only).
:Every 200 hours (yearly)
10) Replace fuel lines. :Every 200 hours (yearly)
11) Clean and inspect the complete engine.
Replace any damaged or worn out parts.
:Every 200 hours
12) Replace packings and gaskets with new
ones.
:Every reassembling