Filter
Top Products
12
Installing water supply
Attach the tank holder on the tank. The tank holder should be
attached around the portion shown with the dotted line.
Tighten the screw (A) to the extent that the tank can still turn
within the tank holder.
Attach the tank holder onto the motor housing. Tighten the
screw (B) securely.
Connect the cap on the end of the polyvinyl tube to the
mouth of the tank. Turn the tank clockwise when making the
connection. Then tighten the screw (A) securely to secure
the tank.
CAUTION:
• If you find the polyvinyl tube is bent like a “V” or has
been strained excessively after installing the water
supply, loosen the screw (B) and adjust the position of
the tank to alleviate the bent, pinched or strained
condition.
Water supply
Remove the cap on the tank and fill through the hole. Recap
the tank. Be sure that the water cock is turned off when filling
the tank with water.
CAUTION:
• When filling the tank with water, be careful not to let the
tool get wet.
1. Tank holder installing portion
2. Tank
3. Screw (B)
4. Screw (A)
5. Tank holder
1
3
4
5
2
003538
1. Screw (B)
1
003539
003541
1. Cap
1
003542