Filter
Top Products
Switch action
To
start the tool, move the switch lever
to the
“ON”
position. To stop, move the
switch lever to the
“OFF”
position.
Operation
*Set the tool base on the workpiece to be cut without the bit making any contact. Then
turn the tool on and wait until the bit attains full speed. Move the tool forward over the
workpiece surface, keeping the tool base flush and advancing smoothly until the cutting
is
complete.
0
When doing edge cutting, the workpiece surface should be on the left side of the bit in
the feed direction.
(See
the figure below)
”
:;;eB:w
Feed
direction
,//,/
/////////I/
,‘
(View
from the
tip
of the tool)
I
Correct bit feed direction
NOTE
:
0
Moving the tool forward too fast may cause
a
poor quality of cut, or damage to the bit
or motor. Moving the tool forward too slowly may burn and mar the cut. The proper
feed rate will depend on the bit
size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece,
it
is
advisable to make
a
sample cut on
a
piece of scrap lumber. This will show exactly how the cut will look
as
well
as
enable you
to
check dimensions.
When using the straight guide
or
the trimmer guide, be sure to install
it
on the right side
in the feed direction. This will help to keep it flush with the side of the workpiece.
6