Filter
Top Products
ADDITIONAL SAFETY RULES
1.
Wear hearing protection during extended periods of operation.
2.
Handle the bits very carefully.
3.
Check the
bit
carefully for cracks or damage before operation.
Replace cracked or damaged bit immediately.
4.
Avoid cutting nails. Inspect for and remove all nails from the workpiece
before operation.
5.
Hold the tool firmly.
6.
Keep hands away from rotating parts.
7.
Make sure the bit is not contacting the workpiece before the switch is turned
8.
Before using the tool on an actual workpiece, let
it
run for a while.
9.
Be careful of the bit rotating direction and the feed direction.
On.
Watch for vibration or wobbling that could indicate improperly installed bit.
IO.
Do
not leave the tool running. Operate the tool only when hand-held.
11.
Always switch off and wait for the bit to come to a complete stop before
12.
Do
not touch the bit immediately after operation;
it
may be extremely hot
13.
Don’t smear the tool base carelessly with thinner, gasoline, oil or the like.
removing the tool from workpiece.
and could burn your skin.
They may cause cracks in the tool base.
SAVE THESE INSTRUCTIONS.
A