Filter
Top Products
User Notes
Opening of the hatch beyond the limit of the stays for maintenance etc. is possible by removing
the rubber bung stop. Gently lever the bung stop out. Supporting the lid, disengage the stay from
the lower frame and lay the lid back to approximately 145 degrees, until the upper frame is resting
on the deck.
During normal usage, the stays should remain engaged at all times.
Do not force the lid back or apply pressure as damage will occur to the hatch.
The locking ventilation position is used by closing the handles into the rebate in the lower frame.
Care should be taken not to stand on or load the hatch lid in this position, as damage could occur
to the handle or catch block.
Always wash the hatch with soap, water and a soft cloth.
Never use abrasive or solvent cleaners on the acrylic lid, as this may at a later date damage the
acrylic.
To avoid risk of injury care should be taken to keep hands and limbs clear of stay and lid pinch
zones while operating and adjusting the hatch.
Please Turn Over