Land Pride Z52 Lawn Mower User Manual


 
20
Section 3 Adjustments
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03
Land Pride
Section 3
Adjustments
!
WARNING!
Unless specifically required, DO NOT have engine running
when servicing or making adjustments to the mower. Place
control levers in the park brake position and remove ignition
switch key. Repairs or maintenance requiring engine power
should be performed by trained personnel only. To prevent
carbon monoxide poisoning, be sure proper ventilation is
available when engine must be operated in an enclosed area.
Read and observe safety warnings in front of manual.
Your Accu Z wasadjusted before it leftthe factory and was
checked during pre-delivery setup. However, after start-
up and continued use, a certain amount of break-in wear
will cause some adjustments to change.
Remain alert for unusual noises, theycould be signaling a
problem. Visually inspect the machine for any abnormal
wear ordamage. A good timeto detect potential problems
is while performing scheduled maintenance service.
Correcting the problem as quickly as possible is the best
insurance.
!
WARNING!
Keep your machine clean and remove heavy deposits of trash
and clippings, they can cause engine fires and hydraulic
overheating as well as excessive belt wear.
Clear away heavy build-up of grease, oil and dirt,
especially in the area of reservoir and oil and engine
combustion air; minute dust particles are abrasive to
close-tolerance engine and hydraulic assemblies.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled
personnel. Consult your Land Pride service center when
assistance is needed.
Torque Values
!
WARNING!
Particular attention must be given to tightening the drive wheel
lug nutsand wheel motor nuts. Failure to correctly torque these
items may result in the loss of a wheel, which can cause serious
damage or personal injury.
Refer to “Torque Values” on page 32.
It is recommended that the following be checked after the
first 2hours of initial operation, initially andevery 50 hours
following removal for repair or replacement.
Wheel lug nuts
Wheel motor nut
Blade spindle bolts (top and bottom)
For engine torque values, see engine owner’s manual.
Steering Linkage
The neutral adjustment for the controllevers in the neutral
position is discussed in this section.
The steering has been factory adjusted to eliminate
creeping when the control leversare in the neutral position
(Refer to Figure 3-1).
However, should the mower begin to creep, adjustments
can be made as outlined on the following page.
Control Lever In Neutral Position
Figure 3-1
19078
Control
Lever
Park Brake
Slot