Filter
Top Products
11
Section 1 Assembly and Set-Up
03/11/03
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Land Pride
Bagger Assembly
Refer to Figure 1-8:
1. Remove and retain rear bumper bolts (#3) and flat
washers (#4). Do not remove bumper.
2. Assemble left bracket (#1) and right bracket (#2)
through the same slots using the bolts and flat
washers retained from the bumper.
!
CAUTION!
Muffler can cause burning. Muffler should be cool before pro-
ceeding.
3. Position muffler deflector (#5) on existing muffler
exhaust so that deflector is pointing away from the
plastic containers. Mark forhole throughdeflector (#5)
and drill hole for screw using a #26 (.147) drill bit.
4. Install muffler deflector to existing exhaust and fasten
with screw (#6) through hole in deflector and drilled
hole.
NOTE: Accu-Vac Collection System cannot be
mounted on Accu-Z mowers manufactured with
Honda engines. Use only with Kawasaki engines.
19910
Bagger Brackets and Muffler Deflector Assembly
Figure 1-8
Important
Damage will occur if:
Failure to install and/or adjust muffler exhaust deflector,
will result in damage to either grass catcher container or
mower.
With engine cool:
Install the muffler exhaust deflector onto current muffler
exhaust pipe.
Swivel deflector around so the exhaust is porting away
from bothunit and bagger. Start mower and check air flow
out of deflector. Make sure hot exhaust air is not diverted
onto unit or bagger. Exhaust should be diverted out to
side.
Mark muffler exhaust pipe using hole in diverter.
Drill muffler exhaust pipe using #26 (.147) drill bit.