Land Pride Z52 Lawn Mower User Manual


 
16
Section 2 Operation
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03
Land Pride
5. Perform test to make sure safety start interlock system
is operating properly. Refer to Safety start interlock
system section.
6. As soon as engine begins to run, check to make
certain the oil warning light is off. If not, stop engine
immediately and check for the cause.
7. Allow the engine to idle a few minutes before
advancing the throttle and/or engaging the deck
clutch.
8. Before stopping the engine, place the controllevers in
the brake position, disengage the deck clutch, and
throttle back to low idle for a couple of minutes; then
rotate ignition key counter-clockwise to the OFF
position. Remove the key from switch before leaving
the seat.
!
WARNING!
Never leave the machine unattended with key in ignition switch.
Moving Mower with Stalled Engine
If it becomes necessary to move the mower when the
engine is inoperative, the hydraulic pumps are equipped
with bypass valves. Before moving the unit, turn bypass
valves counter clockwise one-half to one revolution. The
valve stems on each hydraulic pump are located near the
top and are identified as a hex stud. Refer to Figure 2-8.
Do nottow the machine. Move it byhand or use a winch to
load on a trailer for transporting.
IMPORTANT: The engine starter should not be
operated for periods longer then 30seconds at a time.
An interval of at least two minutes should be allowed
between such cranking periods to protect the starter
from overheating and burn-out.
19064
Bypass Valve
Figure 2-8
Bypass
Valve
IMPORTANT: Always make certain the two bypass
valves are returned to their operating position before
running the mower following repairs.
Steering
Figure 2-9
Front of mower Faces This Direction
N
N
Forward Travel Pivot Right Turn Forward Travel
Right Turn
Reverse Travel
Right Turn
Reverse Travel
N= Neutral Position
Direction of arrows indicate direction of mower movement.