Filter
Top Products
34
Section 6: Maintenance & Lubrication
SB1051, SB1064, SB1574, & SB2584 with S/N 881640- Snow Blowers 370-027M
10/08/14
Table of Contents
Gearbox
Remove oil level plug shown with arrow. If oil is below
bottom of plug hole, add recommended gear lube
through oil level plug hole until oil flows out of the hole.
Reinstall and tighten oil level plug.
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil begins to flow out of oil level plug
hole in gearbox.
NOTE: Do not overfill! Snow Blower should be level
when checking oil. Oil expands when hot, therefore,
always check oil level when cold.
33293
SB1051 & SB1064 Gearbox
SB1574 & SB2584 Gearbox
Do Not
Overfill
Do Not
Overfill
33294
NOTE: Use a suction or siphon pump to drain
gearboxes of oil when there is not an oil drain plug.
33302
23759
Driveline U-joints
Driveline U-joint with grease every 8 hours of operation
2 - Zerks
Type of grease = Multi-Purpose
Quantity = Coat Generously
Driveline Shaft
Disconnect driveline shaft from the tractor and slide
apart. Clean and coat the inner tube of the driveline shaft
with a light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
10
Hours
10
Hours
As
Required