Filter
Top Products
8
Section 2: Adjustments
RBT1560, RBT1572 & RBT1584 Rear Blades 301-144M
2/01/07
Land Pride
Table of Contents
Angling and reversing
Refer to Figure 2-1:
Eight holes are provided for angling the blade in either
the forward or reverse position. The blade can be angled
horizontally 45 degrees to each side of center in 15
degree increments.
Blade Angling
Figure 2-1
Pitch
The pitch of the blade can be adjusted by lengthening or
shortening the top link of the tractor.
12051
Blade Tilt
Refer to Figure 2-2:
Five holes are provided for tilting the blade to either the
left or right positions. To tilt the blade pull the hair pin
cotter and pin on the mainframe and rotate the blade.
Reinsert pins.
Blade Tilt
Figure 2-2
Blade Offset
Refer to Figure 2-3:
The blade may be offset 12” right or left by unbolting the
moldboard from the blade mount weldment and then
rebolting it, using alternative holes provided on the
moldboard.
Blade Offset
Figure 2-3
12046
14965
Section 2: Adjustments