Filter
Top Products
12
Section 3 Adjustments
FD1548 & FD1560 3-Spindle Grooming Mower 310-155M
7/18/08
Land Pride
Table of Contents
Transporting
IMPORTANT: Always disengage PTO before raising
the mower to transport position.
When raising the mower to the transport position, be sure
that powershaft does not contact tractor or mower. Adjust
the tractor’s 3-point hitch lift height so that the PTO shaft
does not contact mower deck.
Be sure to reducetractor ground speed when turning; and,
leave enough clearance so the mower does not contact
obstacles such as buildings, trees or fences.
Select a safe ground travel speed when transporting from
one area to another. When traveling on roadways,
transport in such a way that faster moving vehicles may
pass you safely.
When traveling over rough or hilly terrain, shift tractor to a
lower gear.
!
CAUTION
WHEN TRAVELING ON PUBLIC ROADS, WHETHER AT
NIGHT OR DURING THE DAY, USE ACCESSORY LIGHTS
AND DEVICES FOR ADEQUATE WARNING TO
OPERATORS OF OTHER VEHICLES. COMPLY WITH ALL
FEDERAL, STATE, AND LOCAL LAWS.
Belt Tension
Refer to Figure 3-2:
!
CAUTION
Belt drive system under spring tension; use care to avoid bodily
harm!
1. To check tension apply force at arrow A. With a ten-
sion tester anddeflect the belt 1/4".The force required
to get this deflection should range from 7 to 10 lbs.
2. To adjust belt tension, adjust eyebolt (#1), as
necessary. This adjustment will increase or decrease
the tension on spring (#2).
3. Excessive tension on the belt may lead to premature
failure of belt and drive components. Excessive
tension on the belt may also lead to a safety hazard to
the operator or bystanders. Not enough tensionon the
belt may lead to premature failure of the belt due to
excessive slipping.
!
WARNING
Excessive tension on the belt may lead to premature failure of
belt and drive components. Excessive tension on the belt may
also lead to a safety hazard to the operator or bystanders.
Belt Tension
Figure 3-2
12732