Filter
Top Products
17
HOW TO ADJUST THE SPREADING
The material spreading is regulated through the regulation lever that moves the
opening section on the bottom of the hopper. In order to carry out the regulation,
after having consulted the spreading table, acording to the type of material to spread
and to the speed of pulling vehicle, it is necessary to move the lever “A” along the
graduated scale “E” and locking it in the chosen position with pin “D”.
In order to spread from both sides (ref. I), “A” and “B” levers must be in
the same position, connected through grip handle “C”. In order to carry
out the spreading only through the left side (ref. II), it is necessary to
disconnect the two levers removing the “C” grip handle, to set the lever
“B” in the chosen position, given by spreading chart, and to bring the
lever “A” towards the higher part (position1) in order to close the shutter
of the right side. In oreder to spread only to the right side (ref. III) you
have to move lever “B” up, ( in position 1) and regulate the quantity to
spread with lever “A”.