Filter
Top Products
13
OPERATION OF THE MACHINE
Make a check of the spreader before switching it on. Start to work only if spreader is
in perfect condition.
Before using the spreader please be sure that all safety devices are correctly in place
and in good working condition; in case of breakdowns or damages to the guards,
please replace them immediately.
ATTENTION!
During work, please be sure there is no person or animals within 50 meters.
When you work close to roads or public places, it is ABSOLUTELY
NECESSARY to keep people away and to increase the precautions.
ATTENTION!
Anybody who comes up to the spreader while in use is in a danger
area, therefore they become “AN EXPOSED PERSON”. The operator
must prevent anyone from coming into the danger area and work with
maximum caution. If someone comes up, stop spreader immediately.
- Before every use of the spreader, please always check the wear of the vanes and
the spreader disc. Check that all screw and bolts are in and tight.
- The machine must never be unattended while moving.
- Always keep the machine in good operating condition and perform maintenance
regularly.
TRANSFER ON THE ROAD
ATTENTION!
Please follow the Highway Code carefully that is in force for the country
or state you are using spreader in. During transport on public roads it is
necessary to empty the hopper.
Remember that during moving on public roads, special attention must be taken.
refer to possible and special regulations noted on pulling vehicle manual,
choosing the proper speed especially when the street is crowded, winding or
sloping. If the spreader hides the back signal lights of pulling vehicle, it is nec-
essary to put a light bar and/or some back
signaling signs.
During transport on the road, the gearbox must
not be engaged. Switch off the mechanical block
from the axle, as shown in the picture to the right.