Filter
Top Products
38
BONDIOLI- (BYPY)
1). There are 3 white tabs around the cover as shown in (A in FIG. 1). Take a
screwdriver and press against the tabs one at a time with downward angular
pressure toward the end of shaft marked (B in FIG. 2). As you are pressing
tab grasp cover at point marked (B in FIG. 2) and apply pressure against
cover in the direction of arrow, do this for each tab. (Sometimes the other tabs
may relock, if they do you must repeat unlock procedure.) You will feel it click
when the tab releases, after all 3 tabs are released you can slide the cover
down the shaft in direction of (C in FIG. 2).
2) To put cover back into place slide cover back toward end until all the tabs
relock. (You may have to tap lightly with screwdriver or hammer handle).
NOTE: Cover may be longer on some models but, they will come off the
same as above.
EUROCARDAN SERIES 4
1) First you must locate the black tab (D in FIG. 3) put flat screwdriver in slot in
end of tab and turn until the flat side is pointing towards center of shaft. Once
you do this take the thin flat screwdriver and put into slot labeled (E in FIG. 3)
pry tab all the way out as shown in (FIG. 3)
2). There are 3 white tabs around the cover as shown in (G in FIG. 4). You must
line up cover slots and tabs (as shown in FIG. 4, F & G) Take a screwdriver
and press against the tabs one at a time with downward angular pressure to-
ward the end of shaft. As you are pressing tab grasp cover and apply pres-
sure against cover in the direction of arrow, (H in FIG-3) do this for each tab.
(Sometimes the other tabs may relock, if they do you must repeat unlock pro-
cedure.) You will feel it click when the tab releases, after all 3 tabs are re-
leased you can slide the cover down the shaft in PTO
SHAFTS COVER REMOVAL direction of (H in FIG. 3).
3) To put cover back into place slide cover back toward end (be sure tabs and
slots line up) until all the tabs relock. (You may have to tap lightly with screw-
driver or hammer handle). Once they have relocked replace black tab that
was removed with flat side toward shaft center then turn flat side up to lock in
place.
LA MAGDALENA
1) There are 3 black tabs around the cover (K in FIG. 5). Take a screwdriver and
press against the tabs one at a time with downward angular pressure toward
the end of shaft marked (J in FIG. 5). As you are pressing tab grasp cover at
point marked (J in FIG. 5) and apply pressure against cover in the direction of
arrow, do this for each tab.
2) To replace slide cover back toward end and line up black tabs with the holes
PTO SHAFTS COVER REMOVAL