Filter
Top Products
18
SIZING PTO SHAFT
STEP 1
Cutting the PTO shaft to length.
NOTE: Be sure to cut equal lengths
of each PTO shaft section. Clamp
end of PTO shaft in a vice and cut off
shield where marked. (Figure 1-A &
1-B)
STEP 2
Using cut section of the shield as a
guide cut shaft off the same amount.
(Figure 2)
STEP 3
Repeat steps 1 and 2 for other PTO
shaft section.
STEP 4
Use a file to deburr PTO shafts.
Clean up all chips, burrs and filings
from both ends of the PTO shaft.
Note: If you shear the bolt that attaches
the PTO shaft to the gearbox re-
place with a grade 2 bolt only. Re-
placement with another grade of
bolt will void your warranty and may
cause terminal damage to the PTO
shaft, gearbox, or tractor.
Figure 1-A
Figure 1-B
Figure 2