Filter
Top Products
7
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
UPPER BASE TUBE
BASE TUBE LEGS
FIGURE 6
5/16" x 1"
HEX BOLT
ORIGINAL
BOLT
SPRING
5/16" WASHER
FIGURE 7
STEP 6: (Figure 6)
Insert the ends of the base leg tubes into the upper base
tube.
STEP 7: (Figure 7)
Raise the tractor seat and remove the seat springs and the
four bolts from the rear fender using a 1/2" socket.
STEP 8:
If the seat springs were mounted to the rear holes go to
step 9. If the seat springs were mounted to the front holes
go to step 10.
STEP 9: (Figure 7)
Place the base leg tubes onto the rear fender. Attach
the front support brackets to the front holes in the fender
reusing the bolts that were removed. Attach the base
bracket and the seat springs to the rear holes in the fender
using the bolts and washers shown. Do not tighten
completely.
STEP 10:
Place the base leg tubes onto the rear fender. Attach the
seat springs and front support brackets to the front holes.
Use original bolts to attach base bracket to rear holes. Do
not tighten completely.
STEP 11: (Figures 2-5)
Tighten the nuts and bolts assembled in gures 2-5 that
fasten the base leg tubes to the base bracket and the front
support brackets.
STEP 12: (Figure 7)
Center the base leg tubes on the rear fender and then,
using moderate force, tighten the bolts assembled in
gure 7 that fasten the base bracket and the front support
brackets to the fender. Overtightening the bolts may
damage the threaded holes in the fender.
STEP 13:
Skip to CANOPY INSTALLATION on page 9
ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH
SINGLE MOWER DECK SUSPENSION BRACKET