Filter
Top Products
Operating instructions KM 100/100 R / KM 100/100 R P English
25
Battery discharging
warning
Green
Battery is charged
Yellow
Battery is almost dead
! Stop sweeping and charge
battery
Red
Battery flat
— Sweeping system switched off by
control
! Charge the battery
see chapter on "Maintenance"
Flashing red
— Discharge limit reached
— 3 more min. driving possible,
then the sweeper turns itself off
! Then the sweeper cannot be
restarted any more, the battery
must be recharged for at least
3 hours
Decommissioning
Please heed the following if
sweeper is not to be used for a
lengthy period:
! Stand sweeper on a flat surface
! Turn key switch to "0" and
remove key
! Safeguard the sweeping machine
from rolling away
! Clean inside and outside of
sweeper
! Turn off the machine on a
protected and dry place
! Charge the battery and recharge
it at intervals of approx. every two
months
Transport
Transport instructions
! Turn key switch to "0" and
remove key
! Secure the machine with wedges
on the wheels
! Secure the machine with stretch
belts or ropes
Fastening areas
Notes:
Observe markings for fastening
areas on base frame! (chain
symbols)
For loading or unloading the
machine may be operated on slopes
of only up to a max. of 18 %
Cleaning and maintenance
! Stand sweeper on a flat surface
! Turn key switch to "0" and
remove key
Internal cleaning
Danger!
Wear dust mask!
Wear safety goggles!
! Open unit cover, engage stay bar
! Clean with a rag
Note:
The filter cartridge can be cleaned
with water.
Prior to re-inserting it the filter must
be completely dried.
External cleaning
Clean with a damp cloth previously
soaked in mild suds
Note:
Do not use any aggressive cleaning
agents!
Maintenance intervals
Elapsed-time meter
Elapsed-time meter indicates
maintenance interval times.
Maintenance by the
customer
Daily maintenance
! Check the tyre air pressure
! Check roller and side brush for
wear and trapped straps
! Check the function of all
operating controls
Maintenance weekly
! Checking the battery acid level
! Check freedom of movement of
Bowden cables and moving parts
! Check setting and wear of
sealing strips in sweeping area
! Checking the vacuum system
Maintenance every 100 operating
hours
! Check operation of seat contact
switch
! Check tightness, wear and
operation of drive belts (V-belts
and round belts)
Maintenance according to degree
of wear
! Replace sealing strips
! Replacing the sweep roller
! Replacing the side broom
See maintenance tasks chapter for
description
Note:
All service and maintenance work
must be performed by qualified and
skilled personnel.
A Kärcher specialist dealer can be
consulted whenever support is
necessary.