Karcher HDS 1295 Pressure Washer User Manual


 
English HDS Super, HDS 695 S, HDS 745, HDS 895 S, HDS 995, HDS 1195, HDS 1295 10
Once a month
Clean strainer in low water protection
Clean filter at cleaning-agent suction hose
After 500 hours of operation, at least once a
year
Change oil
MAINTENANCE TASKS
The indicator lamp (item.28)
motor/electronics module is
lit
(only HDS 995 and HDS 1295)
* This warning lamp lights up when certain
maintenance work is necessary due to
accumulated operating hours.
* When you open the cover (item 8) of the
compartment (item 6) the electronic display is
visible in the window (item 4).
* Upon completing the necessary maintenance
work the RESET button next to the display
must be depressed at least 7 seconds until
the warning lamp goes out.
Display
Necessary maintenance work
Visual inspection
Check that the high-pressure connections do
not leak
Clean the fuel tank and the filter
Display
Necessary maintenance work
Check that the pump does not leak
Change the pump's oil
Clean strainer in water connection
Clean the strainer (coarse) fitted in front of the
low water protection
Display
Necessary maintenance work
Decarbonise the heating coil *
Descale the heating coil *
Clean/replace the ignition electrodes *
Clean/replace the burner jet *
Adjust the burner *
Display
Necessary maintenance work
Check the overflow valve for leaks *
Check the high-pressure hose *
Clean the handgun
Check the pulsation damper *
* This maintenance work should be performed
only by after-sales service.
Cleaning strainer in water connection
(HDS 745, HDS 695 S, HDS 895 S, HDS 995,
HDS 1195, HDS 1295, HDS Super)
Figure 10
Remove strainer
Clean in water and re-insert
Cleaning strainer in low water protection
(HDS 745, HDS 695 S, HDS 895 S, HDS 995,
HDS 1195, HDS 1295, HDS Super)
Figure 11
Unfasten union nut and detach hose
Figure 12
Take out strainer
If necessary, screw in bolt M8 approx. 5mm to
pull out strainer.
Clean strainer in water
Slide in strainer
Mount hose
Tighten union nut
Cleaning filter at cleaning-agent suction
hose
(HDS 745, HDS 695 S, HDS 895 S, HDS 995,
HDS 1195, HDS 1295, HDS Super)
Figure 13
Pull the cleaning agent suction inlet pipe out
Clean filter in water and re-insert
Changing oil
(HDS 745, HDS 695 S, HDS 895 S, HDS 995,
HDS 1195, HDS 1295, HDS Super)
Figure 14
Provide a collecting container for approx. 1
litres of oil
Loosen starting screw
* Dispose of used oil in appropriate manner or
hand in at a collection point.