Filter
Top Products
8 English
Î STEP 9:
Push the engine switch to the ON posi-
tion.
Î STEP 10:
Open fuel valve.
Î STEP 11:
Set CHOKE lever to the CHOKE posi-
tion.
Î STEP 12:
Pull the starter handle.
If the engine fails to start after 3 pulls,
squeeze the trigger gun to release pres-
sure, and repeat step.
Î STEP 13:
Move back the CHOKE lever to the
RUN position as indicated.
NOTE:
– Always check engine oil and gasoline
before operating your pressure washer.
– Do NOT overfill engine oil
– Move CHOKE lever to the RUN position
once the engine runs warm and stable.
– A WARM start require the CHOKE lever
to be in the CHOKE position.