Karcher G 2000 MK Pressure Washer User Manual


 
English 5
ƽ
WARNING
Do not check for spark with the spark
plug removed.
Do not touch the high-voltage cord or
spark plug cap.
Do not stop the machine by using the
choke lever.
Do not unreasonably adjust the engine
speed.
Do not place hands or feet near moving
or rotating parts.
Do not operate machine with combusti-
ble material in the muffler area.
ƽ CAUTION
Do not touch hot surfaces or allow ac-
cessories to contact hot surfaces.
The machine has hot surfaces which
can cause burns. Operate the unit in a
safe environment and away from chil-
dren.
Remove trash, grass and other debris
from around the cooling fins and recoil
starter.
Allways use new gasoline. Old gasoline
could cause build up in the carburetor
which could cause poor engine opera-
tion.
SAVE THESE INSTRUCTIONS
ƽ CAUTION
When connecting the water inlet to the
water supply mains, local regulations of
your water company must be observed.
In some areas the unit must not be con-
nected directly to the public drinking wa-
ter supply. This is to ensure that there is
no feedback of chemicals into the water
supply. Direct connection via a receiver
tank or backflow preventer, for exam-
ple, is permitted.
Dirt in the feed water will damage the
unit. To avoid this risk, we recommend
fitting a water filter.
Garden hose must be at least 5/8 inch in
diameter.
Flow rate of water supply must not fall
below 2.8 GPM (gallons per minute).
Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
The water supply temperature must not
exceed 104°F/40°C.
Never use the pressure washer to draw
in water contaminated with solvents,
e.g. paint thinners, gasoline, oil, etc.
Always prevent debris from being
drawn into the unit by using a clean wa-
ter source. Use additional water filter.
Do not operate pressure washer without
the water turned on.
WATER SUPPLY
(Cold Water Only)