Filter
Top Products
28 – English
Repair instructions
7.7 Ignition module and flywheel
– removal
1
Remove the cylinder cover. Disconnect the HT lead,
remove the spark plug and t piston stop 502 54 15-
01. in its place. Take off the starter assembly, release
the leads from the cable guide and remove it (see
gure 8).
4
Knock on the punch using a metal mallet until
the ywheel releases from the shaft. Remove the
punch and the ywheel (see gure 10).
Cleaning and inspection
• Clean all parts, especially the tapers on the
ywheel and shaft.
• Check that the ywheel is not cracked or da-
maged in any other way.
2
If replacing the ignition module (B), loosen the
cable lug (C) and screw (A) and unscrew it. The
ignition module can be left in place if you are simply
removing the ywheel (see gure 9).
3
Loosen the ywheel nut (E) using a suitable socket
and remove it (see gure 10).
When replacing the cables, they are tted on the
stop switch, as shown in gure (see gure 9).
Fig 8
Fig 9
Fig 10