Filter
Top Products
English – 37
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Jonsered chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
Bar Chain
Length, inch Pitch, inch Max. nose radius
16-32 3/8 11T Jonsered S42, Oregon 73LP/73LG
0,050"/1,3 mm - 72LP 72LG
0,058"/1,5mm S42 73LP 73LG
0,063"/1,6 mm - 75LP 75LG
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries to the
user. Do not operate this saw unless you have extraordinary cutting needs and experience and
specialized training for dealing with kickback. Saws with significantly reduced kickback potential are
available. Always use the safest saw and cutting equipment applicable to your cutting need.