Filter
Top Products
English – 31
MAINTENANCE
Adjustment of the oil pump
The oil pump is adjustable. Adjustments are made by turning
the screw using a screwdriver or combination spanner. The
machine is supplied from the factory set to 1 turn open.
Turning the screw clockwise will reduce the oil flow and
turning the screw anti-clockwise will increase the oil flow.
Recommended settings:
These recommendations apply to JONSERED chain oil, for
other chain oils increase the oil flow by one step.
Cooling system
To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake on the starter.
2 Air guide plate.
3 Fins on the flywheel.
4 Cooling fins on the cylinder.
5 Cylinder cover (directs cold air over the cylinder).
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.
Centrifugal cleaning “Turbo”
Centrifugal cleaning means the following: All air to the
carburettor passes through the starter. Dirt and dust is
centrifuged out by the cooling fan.
IMPORTANT! In order to maintain operation of the centrifugal
cleaning system it must be regularly maintained.
• Clean the air intake to the starter, the fins on the flywheel,
the space around the flywheel, inlet pipe and carburettor
compartment.
Heated handles
(CS 2163W, CS 2171W)
On models with the model code W, both the front handle bar
and the rear handle are equipped with electrical heating coils.
These are supplied with electricity from a generator built into
the chain saw.
When the red mark on the switch is visible, the heating is on.
Electrical carburettor heating
(CS 2163WH, CS 2171WH)
This machine is equipped with an electronically controlled
carburettor heater.
Applications
The carburettor heater is used in the following temperature
range: ±0ºC or colder. During high humidity, icing of the
carburettor can occur earlier than specified.
The carburettor heater only heats the carburettor when the 3-
way switch is set to position ”II”.
The switch is off in position ”0”, supplies current to the handle
heater in position ”I”, supplies current to the carburettor in
position ”II”.
!
WARNING! The engine must not be running
when making adjustments.
Bar -15": 1 turn from the closed position.
Bar 15" -18": 2 turns from the closed position.
Bar 18" -24": 3 turns from the closed position.
Bar 24" -: 4 turns from the closed position.
1
2
5
4
3