Filter
Top Products
English – 29
MAINTENANCE
throttle for about 10 seconds. Then turn the H-jet 1/4 turn
anti-clockwise. Run the machine at full throttle for another
10 seconds or so and listen to the difference in the fast idle
speed. Repeat this procedure with the H-jet turned a
further 1/4 turn anti-clockwise.
• You have now run the machine at settings of H =±0, H=+1/
4, H=+1/2 relative to the basic settings. At full throttle the
engine has sounded different for each setting. The H-jet is
correctly adjusted when the machine burbles a little. If the
machine ”screams” then the machine is set too lean. If the
muffler emits a lot of smoke and the machine burbles a lot
then the setting is too rich. Turn the H-jet clockwise until
the setting sounds right
CAUTION! To ensure correct adjustment you should enlist
a qualified mechanic who has access to a tachometer.
The recommended maximum fast idle speed must not be
exceeded.
Correctly adjusted carburettor
When the carburettor is correctly adjusted the machine
accelerates without hesitation and 4-cycles a little at full
throttle. It is also important that the chain does not rotate at
idle. If the L-jet is set too lean it may cause starting difficulties
and poor acceleration. If the H-jet is set too lean the machine
will have less power, poor acceleration and could suffer
damage to the engine.
If the L and H-jets are set too rich it will lead to acceleration
problems or too low a working speed.
Starter
Changing a broken or worn starter cord
• Loosen the screws that hold the starter against the
crankcase and remove the starter.
• Pull out the cord approx. 30 cm and hook it into the notch
in the rim of the pulley. Release the recoil spring by letting
the pulley rotate slowly backwards.
• Undo the screw in the centre of the pulley and remove the
pulley. Insert and fasten a new starter cord to the pulley.
Wind approx. 3 turns of the starter cord onto the pulley.
Connect the pulley to the recoil spring so that the end of
the spring engages in the pulley. Fit the screw in the
centre of the pulley. Insert the starter cord through the
hole in the starter housing and the starter handle. Make a
secure knot in the end of the starter cord.
Tensioning the recoil spring
• Hook the starter cord in the notch in the pulley and turn
the starter pulley about 2 turns clockwise.
CAUTION! Check that the pulley can be turned at least a
further 1/2 turn when the starter cord is pulled all the way
out.
Changing a broken recoil spring
• Lift off the pulley. See instructions under heading
Changing a broken or worn starter cord.
• Remove the recoil spring from inside the pulley by tapping
the pulley lightly with its inside face downwards against a
work bench or the like. If the spring pops out during fitting,
wind it up again, working from the outside in towards
centre.
• Lubricate the recoil spring with light oil. Fit the pulley and
tension the recoil spring.
!
WARNING! When the recoil spring is wound
up in the starter housing it is under tension
and can, if handled carelessly, pop out and
cause personal injury. Always be careful
when changing the recoil spring or the
starter cord. Always wear protective
goggles.
H