Filter
Top Products
10 Operation
5WPMAN0100 (Rev. 5/2/2008)
OPERATION
The operator is responsible for the safe operation of
this overseeder. The operator must be properly trained.
Operators should be familiar with the equipment, the
tractor, and all safety practices before starting opera-
tion. Read the safety rules and safety decals on pages
5 to 8.
Recommended tractor ground speed is from 2 to 5
mph (3 - 8 kph).
Power unit must be equipped with ROPS or
ROPS cab and seat belt. Keep seat belt securely
fastened. Falling off power unit can result in death
from being run over or crushed. Keep foldable
ROPS system in “locked up” position at all times.
Never allow children or untrained persons to
operate equipment.
Keep bystanders away from equipment.
NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equipment
or between moveable parts even when the engine
has been turned off. Hydraulic system leak down,
hydraulic system failures, mechanical failures, or
movement of control levers can cause equipment
to drop or rotate unexpectedly and cause severe
injury or death.
• Service work does not require going under-
neath.
• Read Operator's Manual for service instruc-
tions or have service performed by a qualified
dealer.
Keep hands, feet, hair, and clothing away from
equipment while engine is running. Stay clear of all
moving parts.
Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
OVERSEEDER ROLLER OPERATION
The Overseeder is an excellent turf reconditioning tool.
Its ground penetration promotes a healthy root system
by allowing water, air, and sunlight to enter the roots.
For best results, adjust the overseeder level front to
back so that the front and rear rollers work together.
Control fore and aft pitch by adjusting the tractor's top
link length.
Front Rollers
When the front rollers are straight (Figure 1) and the
overseeder is pulled forward, the large front pins will
penetrate the soil in a straight pushing action, and little
disturbance is caused to the turf.
Figure 1. Front Roller in Straight Position
CAUTION
CAUTION