Filter
Top Products
ASSEMBLY
12
MTF-0410104L
SNOW CHUTE ASSEMBLY
1. Remove back carriage bolt (See Figure 11).
2. Tilt chute back into operating position.
3. Replace carriage bolt from inside of chute.
4. Replace flatwasher and nylon locknut on outside of
flange.
5. Tighten carriage bolt securely.
NOTE: check all carriage bolts in flange for tightness.
DO NOT overtighten.
Chute Deflector
Operating
Position
Flange
Carriage Bolt
Flatwasher
Locknut
Figure 11
CHECK THE TIRES
The tires were over inflated for shipment. Check the tire
pressure in the tires. See the sidewall of the tire for the
proper inflation.
IMPORTANT! BEFORE YOU START
OPERATING
r Check the fasteners. Make sure all fasteners are
tight.
r On electric start models, the unit was shipped with
the starter cord plugged into the engine. Before
operating, unplug the starter cord from the engine.
NOTE: This snow blower was shipped WITH OIL in the engine. See “Before Starting Engine” in-
structions in the Operation section of this manual before starting engine.