Filter
Top Products
ASSEMBLY
11
MTF-0410104L
REMOTE CHUTE CONTROL KNOB
1. Thread the knob onto the lever as far as possible. Make
sure that the knob points forward (See Figure 8).
2. Tighten the jam nut against the knob securely.
SPEED SELECT KNOB
1. Thread the knob onto the lever as far as possible. Make
sure that the knob points forward (See Figure 8).
2. Tighten the jam nut against the knob securely.
Figure 8
Nut
Lever
LIp
Knob
HOW TO INSTALL
THE SPEED CONTROL ROD
1. Put the speed select lever to the NEUTRAL position.
See Figure 9.
2. Attach the ball joint, located on the bottom end of the
speed control rod, to the shift yoke assembly. See
Figure 10. The fasteners (washer and nut) are in the
parts bag.
3. The length ot the ball joint and speed control rod have
been pre-adjusted at the factory. If an adjustment is re-
quired, loosen the nut. Remove the fasteners to discon-
nect the ball joint from the shift yoke assembly. To
lengthen or shorten the speed control rod, turn the
adapter to obtain the correct length.
4. Make sure the speed select lever functions correctly.
Move the speed select lever through all speeds.
Speed Select Lever
Figure 9
Figure 10
Speed Control Rod
Nut
Adapter
Ball Joint
Shift Yoke Assembly
Fasteners