Filter
Top Products
CAUTION: Stand clear of bands when cutting as they could be under sufficient tension to
cause them to fly loose. Take care in removing bands and wire. They often have extremely
sharp edges and cut very easily.
NOTE: Assembly will be easier if all parts are loosely assembled before tightening the hardware. All
hardware needed for assembly will be found in the hardware bag or on the machine.
To assemble the spreader do the following:
1. Attach four spreader wings (see #20, fig. 4) to the spreader disc (see #19, fig. 4) with eight
M6x16 hex bolts (see #36, fig. 4), Ø6 lock washers (see #37, fig. 4) and M6 hex nuts (see #38,
fig. 4).
2. Locate scaled rod assembly (see #17, fig. 4) in hardware bag. Install scaled rod to main frame
using M8x30 hex bolt (see #29, fig. 4), Ø8 lock washer (see #30, fig. 4) and M8 hex nut (see #28,
fig. 4) that are already installed on the scaled rod assembly.
3. Install protection (see #4, fig. 4) on spreader frame using two M8x20 hex bolts (see #26, fig. 4),
two Ø8 flat washers (see #27, fig. 4) and two M8 hex nuts (see #28, fig. 4).
4. Slide hopper (see #3, fig. 4) onto the output shaft of the gearbox.
FERTILIZER SPREADERS OPERATOR’S MANUAL
GENERAL INFORMATION 9 FRONTIER
Fig. 4 - Models SS1067B & SS2067B assembly.