Filter
Top Products
operation. If it was necessary to remove the PTO shielding to do any of the above operations, do not
forget to replace it.
3.05 - Start Up
CAUTION: Load hopper with product only after the spreader has been properly attached to the
tractor.
WARNING: Chemicals may cause eye, skin or breathing problems. Always wear a face mask,
gloves and goggles when filling hopper. Refer to chemical manufacturer’s label for specific
safety information.
Before starting to use, never forget that the operator is responsible for the following:
1. Safe and correct driving of the tractor and spreader.
2. To learn precise, safe operating procedures for both the tractor and the spreader.
3. To ensure all maintenance and lubrication has been performed on the spreader.
4. To have read and understood all safety aspects for the spreader in the operator’s manual.
5. To have read and understood all safety decals on the spreader.
6. Checking the tractor tires for the proper pressure in accordance with the tractor operator’s manual.
7. Checking that all safety shields are on the machine and securely in place.
8. Making sure the proper attire is worn. Avoiding loose fitting clothing which can become entangled.
Wearing sturdy, tough-soled work shoes and protective equipment for eyes, hands, ears and
head. Never operate tractor or implements in bare feet, sandals or sneakers.
9. Ensuring proper lighting is available, sunlight or good artificial lighting.
WARNING: Use a tractor with a cab and appropriate filters on the ventilation system or wear a
breathing mask capable of filtering toxic powders to prevent inhalation of product.
Prior to start working do the following:
1. Make sure there are no obstructions.
2. Run machine under a no-load condition for a short while to assure that everything is functioning
properly.
3. Adjust all settings for the desired quantity distribution and spread pattern.
4. Shift the transmission to a slow speed gear and start forward, increase the ground speed by
shifting upward until the desired speed is obtained. Do not use in reverse unless absolutely
necessary and only after careful observation of the area behind the spreader.
5. Ballast may need to be added to tractor to maintain steering control.
3.06 - Operating Techniques
WARNING: Before adjusting the spreader or filling the hopper, be sure the tractor PTO is not
engaged, the tractor is shut off, and the key is removed from the tractor ignition.
FERTILIZER SPREADERS OPERATOR’S MANUAL
OPERATION 17 FRONTIER