Filter
Top Products
3. The operating power is supplied from tractor PTO. Refer to your tractor manual for PTO
engagement and disengagement instructions. Always operate PTO at 540 rpm. Know how to stop
the tractor and machine quickly in case of an emergency.
4. When engaging PTO, the engine rpm should always be low. Once engaged and ready to start
operating, raise PTO speed to 540 rpm and maintain throughout operation.
5. Check the tractor master shield over the PTO stub shaft. Make sure it is in good condition and
fastened securely to the tractor. Purchase a new shield if old shield is damaged or missing.
6. After striking an obstacle, disengage the PTO, shut the tractor down and thoroughly inspect for
damage before restarting.
7. To park the vehicle safely, stop vehicle on a level surface (not on a slope), disengage PTO,
engage the parking brake, stop the engine, remove the key, and wait for engine and all moving
parts to stop before leaving the operator’s seat.
8. Stay clear of rotating drivelines. Entanglement in rotating driveline can cause serious injury or
death. Wear close fitting clothing. Stop the engine and be sure PTO driveline is stopped before
getting near it.
2.03 - Messages and Signs
1. Read and adhere to all safety and operating decals on this machine (see fig. 6).
2. Before dismounting tractor: Stop engine, set brake and remove the key of unattended equipment.
3. Keep away from rotating parts and driveline.
4. Keep guards and shields in place and in good condition.
5. Do not use with bystanders in area.
6. Allow no riders on tractor or fertilizer spreader.
7. Allow moving parts to stop before repair.
8. Securely support fertilizer spreader before working underneath.
Additional warning and operating decals are available at no extra charge. Please specify model and
serial number when ordering.
Fig. 6 - Safety decals - driveline; replace immediately if damaged.
FERTILIZER SPREADERS OPERATOR’S MANUAL
SAFETY PRECAUTIONS 12 FRONTIER
outer tube
outer shield