Filter
Top Products
1. The blade turns in a counter clockwise direction when viewed from the bottom of
the deck. The cutting edge must be towards the direction of rotation. The lift wing of
the blades is closest to the deck and the cutting edge away from it (see fig. 11).
2. Install the cup washer (see fig. 11) over the blade bolt and secure the blade in place
as described above.
3. With a wrench, block the spindle and tighten the bolt to 103 lb. ft. (see fig. 12).
4. To remove the blades reverse the procedure.
WARNING: Do not substitute blades or any bolt for the blade retaining bolt.
Company blades and blade retaining bolts are specially made for this application.
Using non original parts can effect the quality of cut and may also cause damage
to the mower.
DANGER: Proper torque must be used when tightening the blade retaining bolt. If
these safety precautions are not followed, the blade could come off during
operation and be thrown hundreds of feet from the mower.
M
AINTENANCE
26 FRONTIER
G
ROOMING
M
OWER
O
PERATOR
’
S
M
ANUAL
Fig. 11
1
3
5
7
8
9
2
4
6
10
11
1. grease fitting
2. hexagonal nut
3. pulley
4. rotor support
5. cover
6. shaft
7. blade
8. cup washer
9. blade bolt
10. cutting edge close to ground
11. lift wing
Ground
Mower's spindle assembly.