Filter
Top Products
IMPORTANT: Very low cutting heights should be avoided. Damaging shock loads
occur when the blades strike the ground repeatedly. This can cause damage to
the mower.
Cutting lower than 2” under most circumstances should be avoided.
The cutting height is adjustable from 1” to 5”.
A front anti-scalping roller is also available upon request. This accessory is particularly
helpful when cutting over uneven terrain
4
.
3.04 - Pre-Operational Check
IMPORTANT: Check each of the following, carefully, prior to engaging the equipment:
1. The spindle bearings have been greased.
2. The belts for proper tension.
3. The oil in the gearbox.
4. The driveline cross and bearings have been greased.
5. No wrappings or foreign objects are around the blades, belts or driveline.
6. The blades are properly installed and the blade bolts properly torqued
5
.
7. All hardware is tight.
8. The tractor, to ensure correct direction of PTO and rpm speed.
9. All safety shields and guards are in place and tightly attached.
10.No people or animals are in the work area.
11.When working, make sure the tractor hitch is in the “float” position, in order to allow
the mower to follow the contour of the ground.
O
PERATION
14 FRONTIER
G
ROOMING
M
OWER
O
PERATOR
’
S
M
ANUAL
5
See Table 1, page 31.
4
The GM2084 mower comes standard with the front anti-scalping roller.
Fig. 5
The cutting height is
adjusted by moving
the height adjustment
spacers on the wheel
yokes above or below
the wheel arm.