Filter
Top Products
30 Assembly
5WPMAN0511 (Rev. 5/9/2008)
Install Top Link
Figure 30. Top Link Assembled
1. Insert cap screw (40) through rear offset links (9),
pipe (30), U-bracket (11) and front offset links (10)
as shown and tighten securely with nut (44).
2. Tighten hardware on rear frame lug and offset link.
Install Rear Caster Arm
Figure 31. Rear Caster Arm Installed
1. Remove rear caster wheel assembly (20) from
shipping position and install as shown in Figure 31
using the same bolts (60) and nuts (44).
2. Repeat for opposite side.
3. Tighten bolts so that caster arm is snug against
deck bracket, but not fully torqued.
NOTE:Refer to Front Caster Wheel Interference
Check, page 13 for possible front caster arm posi-
tions.
4. Attach front caster arm in desired position and
tighten snug against deck bracket.
Torque Caster Arm Hardware
1. Lift mower off shipping pallet and set on a hard
level surface. This allows clearance in the caster
wheel assemblies to be equalized.
2. Tighten all cap screws and nuts on all four caster
wheel arms.
3. Torque all cap screws and nuts to 85 lbs-ft.
Install Driveline Shield
Attach shield (2), Figure 32, to gearbox (1) with cap
screws (5) and flat washers (4).
Figure 32. Rear Driveshaft Installation
11
10
44
40
9
CM757
30
CM757
9. Link, rear offset
10. Link, front offset
11. Link, U-bracket
30. Sleeve, .62 x .84 x 2.88
40. Screw, HHCS 1/2 NC x 4-3/4 GR5
44. Nut, flanged lock 1/2 NC
20
44
60
20. Caster arm assembly
44. Nut, flanged lock 1/2 NC
60. Screw, HHCS 1/2 NC x 1-3/4 GR5
A. Gearbox input shaft
B. Locking collar
C. Anti-rotation chain
1. Gearbox
2. Shield
3. Driveline
4. Washer, flat standard 5/16
5. Screw, HHCS 8 mm x 1.25P x 16 mm