Filter
Top Products
Installing or removing blades
If the mower blades need to be installed, do the following:
1. The blade turns in a counter clockwise direction when viewed from the bottom of
the deck. The cutting edge must be towards the direction of rotation. The lift wing of
the blades is closest to the deck and the cutting edge away from it (see fig. 12).
2. Install the cup washer (see fig. 12) over the blade bolt and secure the blade in place
as described above.
3. With a wrench, block the spindle and tighten the bolt to 103 lb. ft. (see fig. 13).
4. To remove the blades reverse the procedure.
WARNING: Do not substitute blades or any bolt for the blade retaining bolt.
Company blades and blade retaining bolts are specially made for this application.
Using non original parts can effect the quality of cut and may also cause damage
to the mower.
MAINTENANCE 27 FRONTIER
G
ROOMING MOWERS OPERATOR’S MANUAL
Fig. 12 - Spindle assembly.
1
3
5
7
8
9
2
4
6
10
11
1. grease fitting
2. hexagonal nut
3. pulley
4. rotor support
5. cover
6. shaft
7. blade
8. cup washer
9. blade bolt
10. cutting edge close to ground
11. lift wing
Ground