Filter
Top Products
2. Work to be sheared must be squared against the
squaring guide.
3.
Adjust the hold down to within 1/4"above the
table when the shear blade is in the up position
by turning two hex cap bolts (A, Fig. 7). When
the blade starts it's downward travel, the hold
down should immediately hold thework piece in
place.
To prevent distortion, "snap"the handle to facilitate
piercing when notching.
To adjust lower shear:
1. Loosen two hex cap screws (8, Fig. 7) on each
end of the table.
2. Use adjusting screws (A, Fig. 8) to narrowthe
gap between the shear and the table to facilitate
cutting of thin material.
Setting Up the Slip Roll
'!\ WARNING
r than 30" (40") 20
.eel!
over the slip rolls
ng fed into the rolls!
cause serious injury
chinel
Hhe
ay
and/or hands!
Note:
If it doesn't interfere with the proposedfinal
shape or design, a slight bend madewith the press
brake on the leading edge will simplify the initial
rolling process.
- 5 -
Fig. 7
Fig. 8