Filter
Top Products
Jacuzzi
©
Whirlpool Bath: Installation and Operation Page 12 BE76000F • December 2007
ENGLISH
PrO
3
OZONE SANITATION SYSTEM
The unit has a PrO
3
Ozone Sanitation System installed. The
ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for 30
minutes, and then it will automatically shut off. Thereafter, every
NOTE: A soft noise is produced by the pump during operation of
the equipment.
PLUMBING
All Luxury Series baths are factory tested for proper operation
and watertight connections prior to shipping. If leaks are
detected, notify your dealer immediately. Do not install the unit.
WATER SUPPLY
Consult local authorities for plumbing code requirements in your
area.
IMPORTANT
compliance with local codes are the responsibility of the installer.
Jacuzzi
©
Whirlpool Bath does not warrant connections of water
Nor is it responsible for damage to the bath which occurs during
installation.
CAUTION
between soldering work and bath unit to prevent damage to the
bath.
CLEAN-UP AFTER INSTALLATION
never use abrasive cleaners or harsh chemicals. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal tools
will scratch the surface. Spots left by plaster or grout can be
removed if lightly rubbed with a mild detergent and a damp cloth
or sponge.
removed by lightly sanding the surface with a 600-grit, wet-dry
like Meguiar’s No. 10 Mirror Glaze. If it is not available, use an
automotive rubbing compound followed by an application of
automotive paste wax.
Major scratches and gouges that penetrate the acrylic surface
®
Whirlpool Bath dealer