Filter
Top Products
J-Sha II Owner's Manual
80-130
130-220
110-150
TIME
SPEED
INTENSITY
+
+
_
+
_
025
_
TONIC
RELAX
+
+
+
_
_
_
MIX
ON
OFF
ON/OFF BUTTON
& LED
TIME BUTTON
& LED SCALE
SPEED BUTTON
& LED SCALE
INTENSITY BUTTON
& LED SCALE
MIX BUTTON
AIR INCREASE
& DECREASE
BUTTONS & LED
MIX
Both back jets and body jets operate in this mode.
Press MIX button:
BACK JETS and BODY WEIGHT LEDs remain off.
INTENSITY indicator will be completely lit. The dura-
tion of this cycle is about 20 minutes. The back jets
flow is from lower to upper jets with gradually increas-
ing speed.
TONIC/RELAX MODE
VARIATIONS FROM DEFAULT SETTINGS
BODY WEIGHT AND ROLLING OR SQUARE :
Body weight and rolling or square function can not be
set during MIX mode.
TIME, SPEED and INTENSITY:
Repeatedly press + or - buttons for each function.
Variations from the standard value are displayed by
the relative LED scales.
AIR:
The default for body jets is air off. Press the upper
AIR button to turn on the air flow. The LED turns on.
Press the upper button to increase the air flow from
the body jets. Press the lower air flow to decreases
air flow. When the LED goes off, the air is off.
For pulsating air flow, press and hold the upper or
lower air button twice. The LED flashes to indicate
this mode. To turn off press either button once again.
MIX OPERATION (BACK AND BODY JETS)
11
IMPORTANT
When exiting the bath, the water level will drop below the back jets which could result in water being sprayed out of
the unit. To prevent this, you must turn off the unit before exiting the bath.