Jacuzzi J - 460 Swimming Pool Vacuum User Manual


 
Page 18
J-400 Series
1. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.
Refer to the table below for approximate water ll volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your hot tub for
any reason! These chemical may damage components within
your hot tub, burn or irritate your skin, create a rash, and void
the manufacturer warranty for your spa.
!
Water Fill Volume by Model
Spa Model Approximate Fill Volume Sodium Dichlor
J-460 ...................409 US Gallons (1,548 Liters) .............. 10 oz.
J-465 ...................480 US Gallons (1,817 Liters) .............. 12 oz.
J-470 ...................535 US Gallons (2,025 Liters) .............. 13 oz.
J-480 ...................570 US Gallons (2,158 Liters) .............. 14 oz.
2. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
pillows and plastic knobs from chemical attack. If spa is
indoors, open doors and windows for proper ventilation.
Turn on all spa jet pumps for one hour, open all air
controls, and place all massage selector knob(s) in their center
“combo” position as shown.
Note: You will need to activate the jet pumps every 20 minutes since
these functions have an automatic 20 minute time-out that turns them off.
WARNING: RISK OF PERSONAL INJURY!
To decrease the risk of injury, drowning or entrapment,
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small
children and animals!
Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
!
3. Turn off power to the spa at the circuit breaker, then drain tub as
outlined in section 13.2 (page 45).
4. Rell spa with clean tap water from garden hose until water covers
all jets but does not touch the bottom of the lowest headrest with all
headrests in their lowest position (DO NOT OVERFILL!)
B C
A