Filter
Top Products
J-200
10.0 Operating Instructions
The spa control system has automatic functions that operate upon
start-up and normal operation to protect the system. Upon power up, the
readout displays the following information:
1. Control panel displays current software
release (3.57 or 5.57 depending on spa
model) then;
2. Control panel displays “888” and all indica-
tor LEDs are lit, permitting visual inspection
of all display segments and indicator lights
for proper operation.
3. After the initial start-up sequence ends, the
actual water temperature is displayed. If
water temperature at this time is less then the factory default tem-
perature setting of 100°F (38°C) and the spa is set to either standard
ltration/heating mode (Sections 11.1-11.2, page 28), the heater will
turn on and run until the water temperature rises to the factory set-
ting, then turn off.
Note: It is common for the heater to turn on after the spa is rst lled
because tap water is often very cold.
10.1 Setting Water Temperature
The spa’s thermostat provides optimum control of water
temperature. The temperature set point (set temperature)
can be adjusted from 65-104°F (18-40°C). To raise the set
temperature, press the WARMER ( ) button. To lower
the set temperature, press the COOLER ( ) button. The rst press of
either WARMER ( ) or COOLER ( ) button displays the set
temperature. To access the overtemp feature
that allows the spa to reach 106°F (41°C)
follow the steps below (Figure 1).
A. Press and hold the WARMER ( ) button
then;
B. Press and hold the JETS 1 (
1
) button at
the same time for 2 seconds. You will see
the temperature rise to 106°F (41°C) on the LED display. To lower the
temperature, press the COOLER ( ) button.
C. When the overtemp feature has been activated, the white decimal
point after the last digit will ash on and off every second as an
indicator for being in the overtemp mode.
Note: Once the temperature goes below 104°F (40°C) and you would
like to raise the temperature to 106°F (41°C) again, you will have to
repeat the steps above.
10.2 Activate Jet Pumps
The control panel JETS 1 button activates jets pump 1. The rst press
activates low speed, the second press activates high speed, and the third
press shuts jets pump 1 off. The JETS 2 button activates jets pump 2.
1.
2.
3.
Spas with
Circulation
Pump Option
Spas without
Circulation
Pump Option
1
2
A
B
C
Figure 1
26