Filter
Top Products
page 23
11.2 Economy Filtration/Heating Modes (F4-F6)
Economy filtration/heating modes are typically selected by customers in
warm climates where heat up times are minimized due to higher ambi-
ent temperatures. In these modes, the water temperature is regulated
by the set temperature, low-speed pump, and heater only while a pro-
grammed filtration/heating cycle is running. Note: these modes con-
sume less energy than standard modes F1-F3 outlined in the previous
section.
11.3 Lock Modes (L1-L2)
These modes are designed for use during spa service or to prevent
unauthorized use.
11.4 Selecting The Skimmer/Heating Mode
Press and hold both control panel WARMER ( + ) and COOLER ( - )
buttons at the same time, then release. Then press either WARMER
( + ) or COOLER ( - ) button to select skimming/heater mode F1-F6 or
lock modes L1-L2 on below:
Standard Filtration/Heating Modes (F1-F3)
F1 4 hours of filtration/heating per day (one 2-hour cycle
every 12 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle
every 12 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter clean-
ing)
L2 Lock Mode (disables the jets and light buttons to pre vent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled. Example:
the “F3” filtration/heating cycle was enabled prior to choosing lock
mode. The spa continues to perform the “F3” cycle until lock mode
is canceled,