Filter
Top Products
15
if the equipment is repaired by unauthorised personnel, or using
spare parts other than the original ones produced by Jacuzzi
Europe.
Warnings and notes
The Flexa Twin is not a toy. NEVER LEAVE UNSUPERVISED
CHILDREN IN THE SHOWER ENCLOSURE, PARTICULARLY
DURING THE OPERATION OF THE TURKISH BATH.
Jacuzzi
®
shower enclosures can be used for household pur-
poses and other similar uses, and must not be installed out
of doors. Make sure that the installation is carried out by
qualified technicians, in compliance with the laws and reg-
ulations in force in the country where the shower enclosure
is installed.
It is dangerous for a person inside the shower enclosure to
use devices connected to the electrical network: no electri-
cal devices must be accessible from the shower enclosure.
In the Turkish bath, the peak temperature, at the height of
the user’s bust, is approximately 45°C, allowing for a room
temperature of approximately 20°C.
ƽ
IMPORTANT! The steam comes out at a temperature
near 100°C. During the Turkish bath, do not keep your
legs, or other parts of your body, in the trajectory of
the steam jet; or keep them at least 40 cm away from
the steam outlets.
ƽ
IMPORTANT! When you use the Turkish bath, do not
position the seat above the steam outlet on the tub,
on the side of your feet (see the figure below).
Do not use water at a temperature higher than 60°C: this
might damage the water circuits and might increase the
formation of scale.
After having used any “water jet” function, turn off the mixer tap
and/or stopcock. It is advisable, moreover, to set the diverter knob
to position “water into tub”.
If the Flexa Twin is supplied with hot water from an economic-type
gas boiler with mechanical flame modulation, the boiler may not be
able to supply water continuously at the required temperature, so
there may be some variations in the water temperature.
In this case, if it is not possible to replace the boiler with an electronic-
modulation one, it is advisable to have a qualified technician lock the
flame modulation of the boiler, in order to use only the mixer tap of the
shower enclosure to regulate the water temperature.
The Jacuzzi
®
thermostatic mixer is suitable for hot water supplied
from pressurized accumulators. If an instant hot water heater is used,
make sure that it has a power of not less than 18 kW (250 kCal/mn).
If a gas model is used, a model with variable power should be used
according to the volume of water to be drawn off.
Do not use hot water accumulators without pressure.
The water mains (hot/cold water) must ensure pressures that are as
balanced as possible: a considerable difference in pressure may pre-
vent a correct and speedy adjustment of the water temperature.
If the water is very hard, it is advisable to install a decalcifying
device, in order to prevent or reduce the formation of scale and to
cut down the need for the scale removal cycle (see the “Use and
maintenance” manual):
The frequent use of the Turkish bath increases the formation of
scale inside the boiler.
Always switch off the master switch after using the shower enclo-
sure and/or hydromassage tub electronic functions (see “Electri-
cal Safety” chapter).
For all maintenance and/or repair operations that require
the replacement of components, you must use original
Jacuzzi
®
, spare parts. Failure to comply with this prescrip-
tion causes the liability of the manufacturer for damages
due to the operation performed to become null and void.