Filter
Top Products
2. Retract the screws so they no longer extend into the azimuth housing on the
mount. Please do not remove the screws, they are needed later for polar
alignment.
3. Hold the Equatorial Mount Head over the Tripod Head so that the azimuth
housing is above the metal Peg.
4. Place the equatorial mount on the Tripod Head so that the two are flush.
5. Tighten the knob (attached to the Central Rod) on the underside of the Tripod
Head to hold the Equatorial Mount Head firmly in place.
6. Slide the Accessory Tray so that the tray is pushing against the inside of the tripod
legs and the Central Rod goes through the tray.
7. Thread the Accessory Tray Knob on to the Central Rod and tighten.