Filter
Top Products
5 OPERATING INSTRUCTIONS
Part No. 1167458
29 Invacare® TheraPure™ Recessed Whirlpool Tubs
5.6 Filling the Tub
1. Close the drain with the blue stopper.
2. Push the tub fill button to start auto-fill.
3. Use the water temperature control valve to adjust the water temperature while watching the flow water thermometer. Test the water
temperature with your hand.
4. After the tub has auto-filled, push in and hold the tub fill button to add additional water.
5.7 Using the Shower/Massage Wand
1. Turn the shower/massage on by pushing the ON/OFF button.
2. Adjust the water temperature using the water temperature valve while watching the flow water thermometer. Test the water temperature with
your hand.
3. Adjust the flow of the water by turning the flow control.
4. Adjust the shower spray by rotating the shower wand head.
5. Turn the shower/massage off by pressing the ON/OFF button again.
ƽ
DANGER - RISK OF SCALDING
Check that the water temperature is between 95° and 105°F (35°C and 41°C) to avoid scalding the resident. Monitor the incoming
water temperature on the flow water thermometer. ALWAYS hand test the incoming water temperature and the water temperature in
the tub.
ƽ
WARNING
DO NOT stand in the tub. The tub surfaces are slippery when wet. Serious injury may occur.
The tub will fill to a predetermined level. To stop the tub from filling, press the fill button a second time (there will be a 5 second
delay). After the tub has auto-filled, push in and hold the tub fill button to add additional water.
Make sure that the Shower/Massage wand is in the cradle and the shower wand head is over the tub. The angle of the wand cradle
can be adjusted to accommodate the user’s need.