Filter
Top Products
5 OPERATING INSTRUCTIONS
Part No. 1167458
21 Invacare® TheraPure™ Recessed Whirlpool Tubs
Perform these procedures in the following order:
1. Make sure that the tub has been cleaned, disinfected and BEFORE use. Refer to Cleaning and Disinfecting
on page 21.
2. Open the tub door.
3. Transfer the resident to the tub.
4. Use the waist strap to help stabilize the resident in the tub as necessary. Refer to Waist Strap
on page 27.
5. Fill the tub.
6. Bathe the resident.
7. Drain the tub.
8. Remove the waist strap (if used).
9. Open the door.
10. Transfer the resident from the tub.
11. Clean and disinfect the tub, including the door seal and waist straps.
12. Leave the door ajar when tub is not in use to avoid compressing the seal. This will prolong the life of the door seal.
5.2 Cleaning and Disinfecting
ƽ
WARNINGS
Clean and disinfect the tub after EACH use to avoid resident infection and contamination of the tub.
DO NOT clean or disinfect the tub when it is occupied. Otherwise injury may occur.
Read and understand ALL information on disinfecting BEFORE use.
ALWAYS wear rubber gloves, an apron and a face shield when using disinfectant. In case of eye or skin contact, follow procedures on the
disinfectant container.
ƽ
CAUTION
NEVER use abrasive cleaners like scouring powder or liquid cleaners containing pumice stone. The use of these types of cleaners will
make the gel-coat finish of your tub scratched and dull. NEVER use cleaners containing Iodine, Household Bleach, Bromine, Betadine® or
Methylene Blue. The use of these types of cleaners will cause the tub to stain. Use of unapproved cleaners will dry out the rubber seals
and gaskets and the tub will not function properly.