Filter
Top Products
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
Part No 1118387 33 Side Entry Whirlpool Tub
FIGURE 4.1 Calibrating the Disinfectant Flow Meter
Troubleshooting
NOTE:Ifproblemsarenotremediedbythesuggestedmeansabove,contactanICCGdealeror
technicalsupport.
SYMPTOMS FAULTS SOLUTION
Hydromassage System
System will not start. No electrical power to tub. Check and reset breaker.
System not prepared. Be sure water level is ABOVE jets.
Check that inlet plug on tub is depressed.
Switch hose disconnected Reconnect hose to switch and motor.
System is ineffective. Water deposits in whirlpool jets. Disassemble and clean whirlpool jets.
Whirlpool jets closed. Open whirlpool jets.
Aerator closed. Open aerator.
Whirlpool intake clogged. Inspect intake and remove obstruction.
Tub Operation
No water flow. Water supply turned off. Turn on water supply.
Restricted water flow. RADA valve. Refer to RADA
owner’s manual
Inspect and clean RADA valve.
Disinfectant Cabinet Door
Floating
Ball
Knob
Flow
Meter
Disinfectant Valve
DETAIL “B”
Screw
Injector
NOTE:Model3650
shown.Models3600
and3600XLhavethe
samecontentsinthe
disinfectingcabinet.
DETAIL “A”
Burp Fitting
Burp Fitting
Models 3600 and 3600XL Model 3650
Disinfectant Siphon Tube
DETAIL
“C”