Support User Manuals

Invacare 3650 Hot Tub User Manual

Open as PDF

of 36

SECTION 2—PARTS AND INSTALLATION

Side Entry Whirlpool Tub 16 Part No 1118387

Securing Tub

NOTE:Forthisprocedure,refertoFIGURE 2.2.

1. Setthetubinplace.

2. Ensureplumbingandelectricalhook‐upshavebeeninstalled.RefertoElectricaland

PlumbingHook‐upLocationsontheTubonpage 17,ElectricalInstallationonpage 17

andPlumbingInstallationonpage 20toensuretheproperhook‐upshavebeen

installedbeforesecuringthetub.

3. Marklocationofanchorholes,usingpre‐drilledholesinlegmountingpadsasa

template.

4. Movetubawayfrommountingarea.

ƽ WARNING

Protective eye wear MUST be worn when drilling to avoid possible eye injury.

5. Drillanchorholesinfloor.Usejack‐drillandcarbidebitinconcreteorawoodbitfor

woodfloors.

6. Repositionthetubinmountingarea,aligningtheholesinthelegmountingpadswith

theholesdrilledinSTEP4.

ƽ WARNING

DO NOT adjust height of legs more than 1 inch (25.4 mm) for Model 3650 or 2

inches (50.8 mm) for Models 3600 and 3600XL; leg will disassemble from leg

mounting pad and serious injury may occur.

7. Levelthetubbyadjustingthetelescopiclegseitherupordown,usingawrench,to

arriveatthedesiredheight.

8. Checktomakesuretubislevelbyplacingalevelonthefrontandsidesofthetub.

9. RepeatSTEPS6and7untiltubislevel.

10. Securelegstofloorusingfastenersappropriatetothefloormaterialandinkeeping

withanylocalcodes.

FIGURE 2.2 Securing Tub

LEVELING END TO END

LEVELING SIDE TO SIDE

Level

Level

Lag

Bolt

Leg

Leg

Mounting

Pad

Anchors

Maximum Adjustment

• 1-inch (25.4 mm) for

Model 3650)

• 2-inch (50.8 mm) for

Models 3600 and 3600XL

Securing Legs to Floor

Lag Bolt

previous next